Euphonix System 5 Spécifications

System 5 Control Surface/FrameVersion 1.0Part# 840-07576-01Publish date: October 1999Euphonix Inc. 220 Portage Avenue Palo Alto , CA 94306Tel: (65

S5 Control Surface/Frame Manual Page 10 Version 1.0 ©1999 Euphonix, Inc.User Reference - FrameAssembling the S5 FrameTools required:• Hex drivers,

S5 Control Surface/Frame Manual Page 11 Version 1.0 ©1999 Euphonix, Inc.3) After the beam is attached to the leg, the auxiliary leg (12 ft frame onl

S5 Control Surface/Frame Manual Page 12 Version 1.0 ©1999 Euphonix, Inc.5) Prior to inserting the palm beam (item 7) into the left leg, thread the b

S5 Control Surface/Frame Manual Page 13 Version 1.0 ©1999 Euphonix, Inc.auxiliary leg can help to hold up the beam.7) Insert as many “T” nuts in the

S5 Control Surface/Frame Manual Page 14 Version 1.0 ©1999 Euphonix, Inc.checked.10) To secure the spread plates into the palm beam ends, pull down

S5 Control Surface/Frame Manual Page 15 Version 1.0 ©1999 Euphonix, Inc.15) Using a 5/32“ hex driver and 1/4x20/3/8 button head screws (044-07236-0

S5 Control Surface/Frame Manual Page 16 Version 1.0 ©1999 Euphonix, Inc.18) If the network, power, and talkback mic cables are not going to enter t

S5 Control Surface/Frame Manual Page 17 Version 1.0 ©1999 Euphonix, Inc.System 5 Ethernet/Power Cable Configuration

S5 Control Surface/Frame Manual Page 18 Version 1.0 ©1999 Euphonix, Inc.System 5 Ethernet Cable HarnessMACHINE ROOMCONSOLEA16-A30A1-A152365(TYP 30 P

S5 Control Surface/Frame Manual Page 19 Version 1.0 ©1999 Euphonix, Inc.CONTROL MODULE SECTION

S5 Control Surface/Frame Manual Page 2 Version 1.0 ©1999 Euphonix, Inc.TABLE OF CONTENTSBox Inventory...

S5 Control Surface/Frame Manual Page 20 Version 1.0 ©1999 Euphonix, Inc.CONTROL MODULES SECTIONPhysical SpecificationsTop View - Control ModulesFram

S5 Control Surface/Frame Manual Page 21 Version 1.0 ©1999 Euphonix, Inc.Filler ModulesCM409F- This is the full-wide blank module for S5 Control surf

S5 Control Surface/Frame Manual Page 22 Version 1.0 ©1999 Euphonix, Inc.Dimensions and WeightModule Weight WidthCM401: 35lbs (16kg) 12”CM402: 35lbs

S5 Control Surface/Frame Manual Page 23 Version 1.0 ©1999 Euphonix, Inc.Control Module Expansion PortGeneral DescriptionOn the back of each System 5

S5 Control Surface/Frame Manual Page 24 Version 1.0 ©1999 Euphonix, Inc.Looking into the FEMALE connector on the module:Looking into a MALE cable co

S5 Control Surface/Frame Manual Page 25 Version 1.0 ©1999 Euphonix, Inc.DB25 Electrical Specification:The +5V output on the connector is protected i

S5 Control Surface/Frame Manual Page 26 Version 1.0 ©1999 Euphonix, Inc.Alternate Usage #1:Another way of using these talkback inputs/outputs would

S5 Control Surface/Frame Manual Page 27 Version 1.0 ©1999 Euphonix, Inc.Alternate Usage #2:Another implementation combines the above two approaches

S5 Control Surface/Frame Manual Page 28 Version 1.0 ©1999 Euphonix, Inc.User Reference – Control ModulesControl Module SetupOverview of Ethernet IP

S5 Control Surface/Frame Manual Page 29 Version 1.0 ©1999 Euphonix, Inc.Self Test Procedure for CM401, CM402 and CM408(For CM40x Firmware Rev 1.0S)T

S5 Control Surface/Frame Manual Page 3 Version 1.0 ©1999 Euphonix, Inc.Switch Test...

S5 Control Surface/Frame Manual Page 30 Version 1.0 ©1999 Euphonix, Inc.Initiating Self TestEnter self-test by pressing the self-test enter keys sho

S5 Control Surface/Frame Manual Page 31 Version 1.0 ©1999 Euphonix, Inc.Self Test OperationsThe operation of each key on the upper and lower board i

S5 Control Surface/Frame Manual Page 32 Version 1.0 ©1999 Euphonix, Inc.Top Level Test KeysTo enter the 6 different tests, use the keys shown below.

S5 Control Surface/Frame Manual Page 33 Version 1.0 ©1999 Euphonix, Inc.LED testThe LED test has the following modes;• Toggle upper board LEDs• To

S5 Control Surface/Frame Manual Page 34 Version 1.0 ©1999 Euphonix, Inc.All Switch LEDs ToggleThis switch toggles all the upper board LEDs on and of

S5 Control Surface/Frame Manual Page 35 Version 1.0 ©1999 Euphonix, Inc.Switch TestSwitch test has the following modes;Momentary switch press - This

S5 Control Surface/Frame Manual Page 36 Version 1.0 ©1999 Euphonix, Inc.Intelligent Display TestDisplay bit test – This test lights up the whole of

S5 Control Surface/Frame Manual Page 37 Version 1.0 ©1999 Euphonix, Inc.Knob Test• Halo Test• Knob value display• Knob meter display• Knob switc

S5 Control Surface/Frame Manual Page 38 Version 1.0 ©1999 Euphonix, Inc.Knob value displayDisplays the hex 0 through FF value of the knob being curr

S5 Control Surface/Frame Manual Page 39 Version 1.0 ©1999 Euphonix, Inc.Fader Test• All fader up• All fader down• Fader cycle test with speed con

S5 Control Surface/Frame Manual Page 4 Version 1.0 ©1999 Euphonix, Inc.Box InventoryDescription Part # QtyS5 Leg Set946-07220-01Leg, Left, Finish

S5 Control Surface/Frame Manual Page 40 Version 1.0 ©1999 Euphonix, Inc.Fader Test (continued)xxxxxxxxMasterGrand182436421206304854607284Center Stri

S5 Control Surface/Frame Manual Page 41 Version 1.0 ©1999 Euphonix, Inc.All fader upAll faders all the way upAll fader downAll faders all the way do

S5 Control Surface/Frame Manual Page 42 Version 1.0 ©1999 Euphonix, Inc.CPU TestRAM TestThis tests the upper unused portion of the CPU board RAM. W

S5 Control Surface/Frame Manual Page 43 Version 1.0 ©1999 Euphonix, Inc.PC104 RAM TestThis test writes and reads the whole PC104 RAM and checks for

S5 Control Surface/Frame Manual Page 44 Version 1.0 ©1999 Euphonix, Inc.CM401/CM408RAM TestROM TestPC104 RAM TestExit Test Key/Exitto main*InputDynE

S5 Control Surface/Frame Manual Page 45 Version 1.0 ©1999 Euphonix, Inc.APPENDIX 1Parts ListsSystem 5 Leg Set: Part# 946-07220-01Item# Item Descrip

S5 Control Surface/Frame Manual Page 46 Version 1.0 ©1999 Euphonix, Inc.Parts List (cont)000-07194-00 1.5" Grommet 1044-06686-00 5/16-18x.375 B

S5 Control Surface/Frame Manual Page 47 Version 1.0 ©1999 Euphonix, Inc.Parts List (cont)System 5 Frame Set, 6ft: Part# 946-06425-01Item# Item Desc

S5 Control Surface/Frame Manual Page 48 Version 1.0 ©1999 Euphonix, Inc.Parts List (cont)System 5 Frame Set, 9ft: Part# 946-06840-01Item#Item Descr

S5 Control Surface/Frame Manual Page 49 Version 1.0 ©1999 Euphonix, Inc.Parts List (cont)System 5 Frame Set, 12ft: Part# 946-07160-01Item# Item Des

S5 Control Surface/Frame Manual Page 5 Version 1.0 ©1999 Euphonix, Inc.7) Servicing – Do not attempt to service the Control Modules beyond those me

S5 Control Surface/Frame Manual Page 6 Version 1.0 ©1999 Euphonix, Inc.Component OverviewFunctional DescriptionThe System 5 Console consists of a fr

S5 Control Surface/Frame Manual Page 7 Version 1.0 ©1999 Euphonix, Inc.FRAME SECTIONPhysical SpecificationsExploded ViewItem No. Qty Description Par

S5 Control Surface/Frame Manual Page 8 Version 1.0 ©1999 Euphonix, Inc. Side Panel ViewItem No. Qty Description Part No. 6ft Part No. 9ft Part No. 1

S5 Control Surface/Frame Manual Page 9 Version 1.0 ©1999 Euphonix, Inc.Dimensions and WeightHeight: 39.5 inchesWidth: Frame size + 10”Depth: